I'm thinking about getting a uni filter, will I need to change the jet? If so where do I buy one and how much are they?

Thanks

 

I have a BBR pipe and Unifilter, no jet change.....im about 800ft above sea leavel..........i did have to adjust the air settings on the carb.......thats it....

 

i would bump up the main get if you are doing that.

60 jet. $5.95

 

how do u change a jet

 

well, i dunno if i'd change the jet, but at least drop the needle...but some guys say that if you change the jet stock you can gain a little???

 

Yea, i think 50s are jetted rich stock for a easy break in.

 

can anyone tell me how to lower the needel or how to put a bigger jet in what will lowering the needel do. thanks

 

Take off the carburator, take off the two screws on the bottom of the carb. Remove the bowl of the carbuator, which is the bottom part. It is the brass circle in the almost dead middle. Take it out with a screwdriver or wrench. Be careful not to strip it because it is brass. Replace and reassemble.

 

you have to take the bras thing out. srry im new to carbs dont want to f*** it up

 

Yup, the brass thing is the jet. My advice is to buy the 60 main jet first. So when you take the carb apart, you know exactly what you are looking for.

 

I got the K&N 62 main jet thing has mucho gusto down low now.

Or maybe it's just the loud noise of the K&N that make you think your going fast?

KB

 

Where a good place online to order a 60 main jet?

 

I just went down to the local Honda dealer...They had the k&n and the 60 Jet in stock

 

Any place that sells factory honda parts.