How hard is it to install graphic kits on the fifty's. Anyone have any tips or stuff to watch out for.

I know when working with vinyl stickers if you use a water/soap solution on the sticky side, you can move it around until its lined up perfect. Will that work with MX graphics.

 

Yeah, but I would also suggest rolling them on... Meaning do not remove all the backing, slide down applying a little at a time... Heat gun is also good... Afterwards though...

Soap is usually a good bet

 

Yes, Get the back of the sticker wet so you can position it perfect that will also eliminate air bubbles..

Then hit it up with the heat gun or hair dryer..