Has anyone had a problem bending frames while stunting? I have been looking ay Planetminis forums and people are always talking about stock frames bending. I know that is probably from jumping and I will be doing a little of that but mainly just tearing up thr neighborhood!

 

My Fiddy doesnt loop as easy as my 600, so i couldnt tell you, LoL. Is it possible to bend it, YES. Look at the rear frame where the 12 bra mounts. Those round tubes arent connected to each other at all. So it wouldnt take much to tweak those. But then again its hard to slap those tubes on the ground without a 12 bar being connected. The bending is probably from jumping, but i would assume it would take ALOT of jumping unless you weigh around 300lbs and you like doing seat standers.....Also, it probably depends on how ones suspension is setup in the rear also. The suspension should absorb the majority of the jumping. So IF you have it stiff as a board, then yeah i would think it would stand better chances at bending............I have an ishock suspension on the rear of mine and hell i dont weigh much at all (soaking wet). So if mine bends, i'll let you know, LoL....=-)

 

I don't bend frames but i'd like to bend you over my knee , you bad boy you

 

I think it would be the other way, since you are the bitch...

 

https://www.stuntlife.com/forums/pos...979-post7.html

 

Been there, seen that, and the answer is still YES. You are the man,,,

 

See , i knew you had a crush on me . You are supposed to like women . Not men

 

Where did you go. Oh, oh. Better get back to fiddylife, I feel more hate coming on... Please don't ban me D.

 

You're a mad cause they banned you over there ? I don't ban anybody . I don't even have that priveledge

 

Don't flatter yourself. It's not a crush, it's a curse...