I'm pissed, launched the fiddy with a 12 attempt gone bad, then go over to see it spitting oil. The crankcase busted from the rear brake pedal bashing into it. Anyone else have to deal with this? I see it's a $130 part. Any cheap fix suggestions? Duct tape? lol

 

The same thing happened to mine. My friend just aluminum welded it. You can also use JB weld. Make sure you clean the area good.

 

Thanks, picked up some JB weld today. Wasn't aware they made something that is supposidly so strong.

 

yep its some good shi*.

 

yea my fiddy did the same thing it was a small hole i just put some jb weld on the inside and out no worrys mate

 

JB weld is the king of quick repair tools, My bud busted a rock threw his crank case, pasted some jb on there and it was good as new

 

Got a nice thick slab on JB drying now. Glad to hear everyone says it works well.

For those of you who have taken the cover off. Everything in mine just fell out. I think I can put it together right but is there anywhere I could check up on to see how it should go? I posted a thread earlier abotu a shop manual for the fiddy, it would help me greatly now, i got a bunch of plates and that doohicky that comes off the shift lever which can go back on the shift level in many different angles. Don't wanna put it together messed up.