i'm starting to do crossover rolling stoppies and i noticed that my handlebars are getting pressed down from my weight. i'm worried that they're going to get stripped out in the triple. i've cranked down the bolts on the cheap *** Pit Posse triple clamps (they're fu(king junk parts) but it still happens. should i :

a) replace the cheap *** triple with a quality one
b) drill a hole into the top clamp through the bars and lock them in place with a
bolt
c) lose a crap load of weight cause i'm a fat ***

 

WELL IF THEY ARE JUNK YOU CAN DO B IF YOU DON'T PLAN ON RESELLING IT WHICH IF IT'S JUNK I WOULDN'T.

THAT SHOULD WORK IF YOU DRILL A HOLE COMPLETELY THROUGH THE TOP OF THE CLAMP AND THROUGH THE BARS AND THROUGH THE BOTTOM OF THE CLAMP.

PEACE

 

i choose "B" drilla hole through and runa bolt. that always worx when my freestyle bike has issues w/ it's neck

 

id say A if you are going to fix something do it the right way dont rig ****

 

with jon on this one. drilling a hole would make the bars weak

 

is it the clamp or the handlebars? you might try a diff set a bars before ya sh!tcan the whole setup jus my

 

take some 40 grit sand paper and ruff up the neck and bars

 

or a punch and put some good divits in there

 

good call!

it's the clamp. it was junk the moment i pulled it out of the box. don't ever buy from Pit Posse.....the product is ****!