03/04 636 parts....all of them
07-07-2010, 09:58 PM
#1
Registered User
Thread Starter
Join Date: Sep 2006
Location: St. Paul MN...
Posts: 11,214
03/04 636 parts....all of them
P.M. or Post up for prices. There are just too many parts for me to figure it all out at once. Make reasonable offers we all know roughly what all this stuff is worth.
03/04 636 Parts
Engine 14,xxx miles prefer local sale
Frame good #s bill of sale
2 subframes black drilled for SI round bar
2 swing arms
Rear ½ frame
Front motor mounts cut from frame
Kickstand
2 rear wheels with rotor
Front wheel slightly bent
Lock set ignition/trunk
Gauges approximately 6,xxx miles
Radiator good mounts/tabs
Riders seat
Passenger seat
Rear seat cowl
Stock header
Fuel pump
Tail cracked after market
Wiring harness
E.C.U.
Voltage regulator
2 O.E. pipes stock/cut
Brake Parts
Set of 03/04 front rotors
Set of 05/06 front rotors
2 sets front calipers
2 rear calipers
Rear caliper bracket
03/04 front master
05/06 front master
1000RR clutch/HB master
Set of blue braided lines f/r
80 inch HB line (new)
Full throttle dual caliper bracket (F4i 4 piston)
Suspension
04 2x10 front end comes with lower triple, axles with spacers, wheel and rotors
03/04 forks
05/06 forks
03/04 lower triple missing a steering stop
05/06 lower triple
03/04 front fender
05/06 front fender
Rear shock
2 shock arms 03/04
Stock links
Lowering links
05/06 shock arm
Controls
3 right side bars
2 left side bars
2 starter switches
Headlight switch
2 O.E. clutch perches/levers
Choke cable
Clutch cable almost new
Throttle with cables
Misc parts
Aftermarket gas cap
2 battery trays
05/06 swing arm pipe cover
Trunk latch and cable
Air box with filter
Left passenger peg bracket
3 - 03/06 front axles with spacers
Rear axle with spacers, alignment blocks
Swing arm bolt
Stock taillight
2 overflow bottles
1 set of mirrors
Rear fender with stock blinkers
107 link 520 EK RXO chain slightly used
Woodcraft swing arm spools 8mm wont fit 636
Also have lots of small, not worth listing, parts. If you need something ask I may have it.
03/04 636 Parts
Engine 14,xxx miles prefer local sale
Frame good #s bill of sale
2 subframes black drilled for SI round bar
2 swing arms
Rear ½ frame
Front motor mounts cut from frame
Kickstand
2 rear wheels with rotor
Front wheel slightly bent
Lock set ignition/trunk
Gauges approximately 6,xxx miles
Radiator good mounts/tabs
Riders seat
Passenger seat
Rear seat cowl
Stock header
Fuel pump
Tail cracked after market
Wiring harness
E.C.U.
Voltage regulator
2 O.E. pipes stock/cut
Brake Parts
Set of 03/04 front rotors
Set of 05/06 front rotors
2 sets front calipers
2 rear calipers
Rear caliper bracket
03/04 front master
05/06 front master
1000RR clutch/HB master
Set of blue braided lines f/r
80 inch HB line (new)
Full throttle dual caliper bracket (F4i 4 piston)
Suspension
04 2x10 front end comes with lower triple, axles with spacers, wheel and rotors
03/04 forks
05/06 forks
03/04 lower triple missing a steering stop
05/06 lower triple
03/04 front fender
05/06 front fender
Rear shock
2 shock arms 03/04
Stock links
Lowering links
05/06 shock arm
Controls
3 right side bars
2 left side bars
2 starter switches
Headlight switch
2 O.E. clutch perches/levers
Choke cable
Clutch cable almost new
Throttle with cables
Misc parts
Aftermarket gas cap
2 battery trays
05/06 swing arm pipe cover
Trunk latch and cable
Air box with filter
Left passenger peg bracket
3 - 03/06 front axles with spacers
Rear axle with spacers, alignment blocks
Swing arm bolt
Stock taillight
2 overflow bottles
1 set of mirrors
Rear fender with stock blinkers
107 link 520 EK RXO chain slightly used
Woodcraft swing arm spools 8mm wont fit 636
Also have lots of small, not worth listing, parts. If you need something ask I may have it.
07-07-2010, 10:11 PM
#6
Registered User
Thread Starter
Join Date: Sep 2006
Location: St. Paul MN...
Posts: 11,214
07-08-2010, 03:15 AM
#10
Registered User
Join Date: Apr 2004
Location: nicholasville, ky
Age: 44
Posts: 215
Re: 03/04 636 parts....all of them
lookin for a package deal 
silver swingarm, kickstand if its got a good switch on it, rear rotor, clutch cable and gas cap. would also like to see the tail an what ya want just for it. thanks man
silver swingarm, kickstand if its got a good switch on it, rear rotor, clutch cable and gas cap. would also like to see the tail an what ya want just for it. thanks man 
07-08-2010, 07:12 PM
#15
Registered User
Thread Starter
Join Date: Sep 2006
Location: St. Paul MN...
Posts: 11,214
