My r6 pics
#1
My r6 pics
Finally got around to getting pics up of my bike. I'll get more later as it will be FF soon.
Big thanks to A-Town for the cage and sub-cage . I decided to make my own sub-frame and 12 bar after breaking my stock one into a few pieces.
07 r6s
08-09 r6r front end & rims
hohey dual cal w/ brembo 16x18
atown cage & subcage
personally fab'd subframe & 12 bar
SI 60t, vortex 15t (520)
My only complaint is the hand brake has no squish, like its hella stiff. Sliders are greased, its bled as good as it gets, line isn't kinked or anything. Any ideas?
Big thanks to A-Town for the cage and sub-cage . I decided to make my own sub-frame and 12 bar after breaking my stock one into a few pieces.
07 r6s
08-09 r6r front end & rims
hohey dual cal w/ brembo 16x18
atown cage & subcage
personally fab'd subframe & 12 bar
SI 60t, vortex 15t (520)
My only complaint is the hand brake has no squish, like its hella stiff. Sliders are greased, its bled as good as it gets, line isn't kinked or anything. Any ideas?
#3
Re: My r6 pics
Thanks man. You just have to cut the butterfly section off so that the can slips in the header, and make a couple brackets to lower the stock header down a bit and to mount the can to the backside of the front peg... It's a little louder than i personally care for though
#7
Re: My r6 pics
I'm actually looking into a maguras, 13mm seems to be the route to go? It's just starting to **** me off that i have to stop riding after like an hour and a half cause my left arm feels like its about to explode from the brake ha
#9
#10
#11
Thread
Thread Starter
Forum
Replies
Last Post