ricroc

that came out soooo clean. i should of took more time to fit mine in my 636. i had to chop the undertail and the tail section was smashed already anyway so i just have the round bar hangin out

chpsk8er630

What did you use to cut the tail? looks good

Righteous 1

Thanks. Used a Dremel w/ a cutting wheel, then just sanded it down a bit.

DURTY

nice. why did it take 4 hours tho??

Righteous 1

Well, in order to retain my tail lights, I had to grind about half of the light housing out, which I did incrimentally. I had to put it together and take it apart about 10 times, maybe more. Each time, I thought I had it......but,of course.....I didn't. I actually bought these red rubber covers for 1157 bulbs, which turn clear bulbs red, just because the round bar actually rests against the bulbs themselves. I had to tape a piece of hard plastic to the flat plate that the round bar welds to because my light contacts were resting up against the flat plate, which would've shorted out immediately. Just took a lot of grinding/thinking. I expected it to take about an hour....LOL.