(1-6)adjuster dial on stock radials
#1
(1-6)adjuster dial on stock radials
any trick to make these not adjust by themselves? I run mine on 4, but when Im rideing it sometimes moves to 6 from the vibration of the engine. last night I clutched up a 4th gear SS(I always clutch straight to BP or behind so I dont gain any speed) went for the HB and squeezed it up against my other fingers. Bike sat behind BP for a second or two, then just barly brang it back,then I pulled over and changed my draws
#2
Re: (1-6)adjuster dial on stock radials
that would make me need to change my draws too lol. what master you runnin? Im runnin the R6/R1 Brembo and never had that happen. What does happen though is someone will ride my bike and change all my **** around but Ive always realized first
#4
#6
Re: (1-6)adjuster dial on stock radials
thanks for the tip,I think I might try taking out the little pentagram thing in the lever,and put a little strip of duct tape around it
#7
Re: (1-6)adjuster dial on stock radials
a gix, I have it linked to 2 calipers so its kinda squishy like a 13mm. on the 4th I can scrape HC all day with 1 finger, but on 6 its a little too close to the bar
thanks for the tip,I think I might try taking out the little pentagram thing in the lever,and put a little strip of duct tape around it
thanks for the tip,I think I might try taking out the little pentagram thing in the lever,and put a little strip of duct tape around it
Thread
Thread Starter
Forum
Replies
Last Post
iRiEsTuNtAh!
Bike Parts for Sale
4
01-20-2013 10:35 PM