Fuwen@Sg

To all the senior, there is a favour i need u guys to help mi. how can i unscrew e long screw n nuts which support e engine? i intent to install a crash bar on my k5. there r 2 points at each side, 1 is e thru for eswim arm, d other hold is belong to e supporting e engine. i m afraid da there might b a misalignment when i unscrew them. pls help.$

mind showing mi e right step to install e crash cage?

problem occured. wat u guys use to make e crash cage stable? i mean e hole we connect using e screw at e engine there?? i will b thankful if anyone can upload some pic. thanks a million

sdfkillz

youre engine wont move when youre installing a cage. if youre afraid that its gonna move just do one side at a time or just but a piece of wood or something under the engine. ive personally never had mine move when installing cages or taking them off.

keithk76

i put a jack under my engine to be sure but its not gonna move anyways. there are no rubber motor mounts like car its bolted solidly to the frame.

Fuwen@Sg

thanks guys. but i had a problem with dis part. pic attach below. i not vv sure how shld i do with dis part. i have check out e powersstuntworx, they do show dis part.

sytfu_RR

I believe thats where you put the threaded rod through, thats how most cages have it setup for the rear mount.

Joker

................................... What they said

Fuwen@Sg

*Anyone mind do share with mi wat's e dimension for ur cage rod inorder to install it? and also,
*wat is e dimension for e bar for e cage? i intent to use a 25mm steel bar for e cage, issit durable enuff? wats ur dimension there ??
*lastly, how to screw e cage to e slider side? can anyone pls post sum pix here? really appreciate.

Fuwen@Sg

any suggestion?