i gat a x18 few days ago,and am haveing some trouble with the damn cluch,its hard to pull the lever in and when you let go,it takes few secs for the full power to kick in,messes my wheelies up.

Dose anyone else have this problem?
would a msr cluch work on these things?

 

sounds like you got some thing sticking like the cable maybe....

 

i thought about it.. could be..i gat to check it tomorrow..takeing the plastics off, is a bitch on these things

 

check if the clutch cable makes good wide curves, and if it's lubed in.
what you mean by "it takes few secs for the full power to kick in",
is it the engine not revving or the clutch not engaging?

 

i checked the cable it moves fine...When i let the cluch out i have to push it out with my fingers for the power to kick in,halfe the time i cant puch it out in time and in few mins my fingers hurt.Theres a spring were the cluch able conects,but it dose not seem to pull the cable well..is there maybe someone i should adjust inside the cluch?

 

I wonder if bike's new.
Chineses aren't japs, you may find flawed bikes once in a while.
I'm starting to think there's something wrong with clutch plates. maybe badly assembled.
All in all, you've done anything else.. time to get to the core of it.

 

i think i made it a little easyer....but it would be great if there was a spring in the lever to bounce it back fast...

 

the clutch should be plenty enough to pull every thing back if it doesn't then you got some thing hanging up

 

not on this bike..lol..its all good i can do power stand up wheelies and sitdowns with out the cluch..or rev the engine in 0 and pop it up in 2nd..:YEAH

thanks for the help dudes