Ok so I got an adjustable cam chine tensioner because my bike had a rattle. I finally got the **** installed after 3 hours what a pain in the ***…..but now how the hell do you adjust the thing there is no room for the wrench . I tightened it little by little by hand until the rattle was gone with the back bolt but I cant tighten the front one to make sure it stays in place, and it seems to want to back it’s self out …. My bike is a 2002 F4i. Can I get some help. THANKS

 

hey were did u get your cct and how did u pay? im about to take on the same task. lemme know if u finally get it set up.

 

^^ our avitar pics are striking similar and we both have cam chain issues .... coincidence... ...or something bigger???

 

i just did mine about 2 weeks ago .. i used a normal wrench and was just paitent with it.. and had to crush the **** outta my hand

 

just use a normal wrench, and **** with it tell you get it

easier if you take off the fuel tank line, and disconnect the wires on the injectors

 

Word up. OMR told me to put a notch in it so you can use a screwdriver and adjust it but I forgot to do that. There's a good write up w pictures on how to install it for the dude looking to do it in the thread below. They cost $45 or $50 on ebay.

https://www.stuntlife.com/forums/444...t-install.html