I like SI materails.

 

i cut my tail back. i just measured it. my tail is 2 1/2 inches from the end of my back seat, and my bar sits flush with the end of my tail.

 

okay, just measure mine too.

n' just FYI, the 905 bar sits exactly 6 and 10/16 inches from the passenger seat.

now he's not pickin up his phone

 

ya my fi pro bar was long as well. but remember i have my tail section cut all the way up to the brake light. i will try to post a pic.

 

 

LMAO

NOOB!

 

lets try that again.

[FONT='Calibri','sans-serif']http://www.johnsdental.com/DNN/1oclockbar.jpg[/FONT]
[FONT='Calibri','sans-serif'] [/FONT]

 

haha, thats better but here is da way to do it:



do u have a pic from the entire rear side of the bike? including the lower portion?

...but it looks good ovevrall...i should have mine mid next week...i'll post up pics when i get it on.

 

i like the round bar so you don't have to worry about getting cut open with the edge of the12 bar trust me that **** hurts when it cuts you open but it is all about your style also

 

[FONT='Calibri','sans-serif']http://www.johnsdental.com/DNN/1oclockbar2.jpg[/FONT]
[FONT='Calibri','sans-serif'] [/FONT]

 

i meant from the side so i can how far back from the tire it is.

 

if i back my bike against a wall. when my tire hits the wall, i still have about 3 inches between the wall and my bar.

 

okay cool....still havn't gotten mine tho i was expectin it today....i'll post up picz when it gets here.

 

okay, first off, 905 sucks!

1. i told him 3 inches back from the pas. seat and its 4-5 inches back.
S

WTF?! i'm gonna call him tomorrow and get this **** straightened out.





also, is the subframe supposed to be curved up like this:

..?

 

okay, first off, 905 sucks!

1. i told him 3 inches back and its 4-5 inches back.
2. the scrape/flat bar isn't even angled right for being further back...which is common ******* sense
3. it doesn't fit nowhere near flush with the subframe like the si round bar does...the side bars are wayyy too far apart!

WTF?! i'm gonna call him tomorrow and get this **** straightened out.





also, is the subframe supposed to be curved up like this:

..?

 

can neone answer my question about the 3rd pic?

 

it's hard to tell exactly what you mean by that pic

 

ohh ya my bad, way too much **** in that pic

i'm talkin about the part that curvs up...wanna see if it bent like that from the last time i looped. (the bar took a hard hit)

 

well the bend i see looks factory but like i said from that pic it is hard to tell and the little dick doesn't help.....lol

i searched ebay to see if i could find a picture of one for you to compare but i could only find the single seat one and there straight

 

...srry about the *****....i was bored

but thats all needed to know, that there IS supposed to be a bend.