Pegs & Brake Lever
#1
Registered User
Thread Starter
Join Date: Jun 2011
Location: Jacksonville Beach, FL, United States
Posts: 46
Pegs & Brake Lever
Just added some 50stunt . com parts and I ran into a couple of issues.
The ground down angle on the rear pegs is wrong. It's set for a much different angle than the stock setup on the CRF50. Just be aware that if you "drag pegs" because of leaning the bike, the rear pegs will drag.
Their foot peg mount with the kickstand will NOT work with a Two Brothers Racing Rear brake pedal. I have to figure something else out here as the pedal is too far out of position to notch it enough to clear the peg mount.
Reshaping of foot peg springs was needed to deal with the 50 stunt foot pegs's different shape. I am not sure about this design as the peg does not fold much. My Two Brothers pegs fold all the way up without any issues.
The 50 stunt hand brake did not have routing instruction for the cable so I hope I have it close nuff'.
The ground down angle on the rear pegs is wrong. It's set for a much different angle than the stock setup on the CRF50. Just be aware that if you "drag pegs" because of leaning the bike, the rear pegs will drag.
Their foot peg mount with the kickstand will NOT work with a Two Brothers Racing Rear brake pedal. I have to figure something else out here as the pedal is too far out of position to notch it enough to clear the peg mount.
Reshaping of foot peg springs was needed to deal with the 50 stunt foot pegs's different shape. I am not sure about this design as the peg does not fold much. My Two Brothers pegs fold all the way up without any issues.
The 50 stunt hand brake did not have routing instruction for the cable so I hope I have it close nuff'.
Thread
Thread Starter
Forum
Replies
Last Post